Laser cutting support heater

Sun, 21 Jun 2026 07:53:30 +0800

Out on the line, the laser cutter doesn’t wait. When the support heater goes down, the whole tempering cell stops cold—glass sits idle, and the risk of thermal shock climbs fast. We built this laser cutting support heater to keep that rhythm intact: steady heat, right where it needs to be, shift after shift. What’s actually under the hood It runs on short-wave infrared quartz emitters, so it responds quickly and holds temperature tightly. You can spec it at 230 V or 400 V, with power from 1.2–3.6 kW depending on the footprint, and the package is compact enough to drop into standard mounting spots. It hits temperature in under 3 seconds, and the active zone stays within ±3 °C of setpoint. The hot zone is laid out for uniform thermal distribution, so you don’t get local hot spots that push the glass into stress fractures during preheat before tempering. Connections are straight-up industrial—robust terminals or DIN connectors, matched to your machine interface. Here’s why it matters in practice. Glass processing is all about timing. In tempering and bending, that laser-cut edge needs predictable preheat so it can enter the furnace without taking a thermal shock. This unit comes up fast, keeps throughput consistent, and holds the thermal profile steady from one batch to the next. The payoff is fewer rejects, fewer surprise stops, and less energy per square meter because the heater cycles efficiently instead of running flat out. It’s designed to drop straight into existing laser cutting support setups as a direct swap—no re-engineering the line. A couple of shop-floor notes. Installation is straightforward, but alignment is where people get tripped up. The emitter array has to be parallel to the glass path; if it’s off, you’ll see uneven heating and start getting edge cracks. The quartz envelope is tough, but treat it clean—keep oils off, and wipe only with a lint-free cloth. In dusty environments, plan routine inspections so coating buildup doesn’t hurt emissivity and throw off temperature control.

Support on Infrared Heat Wave Solutions

Laser cutting support heater